中文版

English

Current location:Home 》news

After the cutting edges of the printing problems

Browsing times9325 Date:2011-10-28 Author:admin

Finishing in a carton die cutting is an important process, cutting a direct impact to the final molding tray. For the printing process of the cutting edges and appear easy to tear easily torn mouth, we interviewed a number of specialized printing and suppliers and ask them to talk about the cause of this problem and generate solutions.

1, the cutting edges of the problem

(1) Group of Xuzhou, Jiang Su Dadong Color Printing Co., Ltd. Huayi

Reason: cutting knife or knives and offensive end of the template of the bits are not allowed.

The solution: replacement of the cutting knife, check the location of the knife and the end of the template are aligned.

(2) Bobst Group Shanghai Co., Ltd.

Reason: cutting knife sharp enough, it could be a rebound on both sides of strip hardness of knife is not enough. When the blade cut into the paper, the paper not fixed, so the blade can not cut together, the paper will produce hair.

Solution: If the new version to be blunt knife, in addition to the possible cause of the equipment itself, but also operating pressure may be set improperly, pressure reducing knife version of the General Assembly life.

2, easy to tear the mouth of the problem difficult to tear

(1) Group of Xuzhou, Jiang Su Dadong Color Printing Co., Ltd. Huayi

Reason: Contact point too

Solution: Contact point should be constantly in the boot large sheet of minimum for the best circumstances, and location of the point associated with the feeding direction of a linear distribution, so that sheets do not work in the oblique cutting machine, the tensile , Union Point is not easy to pull off, joint points can be the smallest mouth to tear the box easy to tear when the tear was.

(2) Bobst Group Shanghai Co., Ltd.

Reason: do not cut through cutting

Solution: First check the version of quality knives, such as quality standards, knife-line highly consistent, sharp blade, then the next check whether there is die cut through the paper part, if any, that should be added pressure. If the part is not cut through, then the pressure is not enough, you can adjust the pressure that some equipment cut through, and then cutting through the added pressure to achieve the desired effect.

In response to these two issues, Jiangsu Unicom Sampoerna Printing Co., Ltd. that these problems are mainly caused by the die cutter. Clear waste in the use of automatic printing machines, blades, cutting die mold better than wood. If there is flash and not easy to tear apart the problem, to check whether the sharp edge, the pressure is too light and so on.

Up Article: Yellow ink printed notes of

Next Article:Will the magic printing knowledge